10 TAKE OUT OF SERVICE
The complete installation can be taken out of service by closing the hand valves for the sampling
points and dp/I-transmitter and switching off:
The air supply to the EPU
The fresh water supply to the skid
The 24 VDC electrical supply to the MCU
The 24 VDC electrical emergency supply to the MCU
The 115/230 VAC electrical supply to the EPU
The 380 – 420 VAC electrical supply to the sample pump motor
11 REMOVAL AND STORAGE OF EQUIPMENT
To remove and store the ODME the following steps have to be taken:
Switch off all air-, fresh water- and electrical supplies.
Make sure that all connections to the skid, EPU and MCU are labelled correctly so that re-
installation can be done without any errors.
Disconnect all the connections in a reverse order as described in section 6.
Store the different parts of the ODME boxes in a cool and dry location, is such way that the
ODME cannot be damaged.
12 MALFUNCTION AND SEND FOR REPAIR
In case of a malfunction, follow the guidelines as described in section 15.
If the ODME cannot be repaired following the guidelines as described in section 15, contact VAF
Instruments for instructions.
In the event parts of the ODME have to be sent back for repair, send it directly to:
VAF Instruments B.V.
Vierlinghstraat 24
3316 EL Dordrecht
The Netherlands
13 ENVIRONMENT
The ODME equipment itself has no negative influence on the environment during normal operation.
Its use is meant to safeguard the environment for the discharge of excessive oil concentrations.
14 DISPOSAL
The ODME equipment is consists of metal, plastics and electronic parts. It should be disposed
according to local laws or regulations.
A green passport can be supplied on request.
90