Control Data 3500 Reference Manual page 17

8CR
=
seg
ABORT
=
dl
RF
=
flg
If the loader determines that a requested task will exceed
the estimated core, the job is terminated with a message on
the OUT file.
When the CORE field is omitted, qp is set by the installation
parameter, core.
Number of segments (250 maximum) of mass storage scratch
area required by the job. Each segment is 10,000 words.
8HO requires approximately one segment for each 400
Hollerith card images.
If the sum of the mass storage requirements indicated by
the line and punch limits (JOB card) and the SCR and ABORT
requests (8CHED card) exceeds the storage reserved for
these files, the job is not initiated.
When the 8CR field is omitted, seg is set to the installation
parameter, scr.
Recovery dump of tasks, dl lines
in
length, is taken
if
the
job is abnormally terminated. MASTE R reserves mass
storage for dl line s of dump.
A non -zero flg indicates that the job will use the Register
File. When any task of the job is interrupted, the contents
of file registers 40-77 are saved. When a task is again
placed in execution, the contents are restored.
'When flg is zero or the field is omitted, the Register File
contents are not saved.
The peq fields schedule an peripheral equipment required
by a job. peq identifies the hardware type; u designates the
number of units or drives of that type required. If peq
requirements exceed system capacity, the job cannot be
scheduled. A job is initiated when all peq requirements
are satisfied.
4-3