Control Data 3500 Reference Manual page 10

If H ...
=
SHO or just H ... appears, COSY creates a scratch file
with dsi
~nless
this file has been already allocated and opened
by a previous COSY run in the same job. Because SHO is released
at the end of the job, it should be used only if assembly or listing of
Hollerith output occurs in the same run. The user must schedule mass
storage scratch for SHO on the MASTER control card, SCHED.
C. . . Specifies the dsi to receive COSY output.
If the parameter is absent, there is no COSY output.
bL
If just C ... appears, COSY output is on
the~ile.
If C ...
=
dsi, output is on the named dsi.
E. . . Specifies the edition number of new COSY output deck.
If E is absent, COSY increases the edition number of the input COSY
deck by one (modulo 100) and inserts the new edition number in the
deck identifier card of the output COSY deck.
If E is absent and the input deck has no edition number, the edition
number on the output deck identifier is 1.
If E. ..
=
n (1::; n::; 99), the output deck identifier card has edition
number n.
T. . . Terminal column parameter stating the number of columns of sig-
nificant information on the input cards.
H)c)v)B
Ci,~
~c)\).J~\Jt'()
f'
f:
If the parameter is absent or just T ... appears, COSY assumes 72
columns of significant information.
Interpretation of the T parameter depends on the type of output
specified, COSY or Hollerith, as shown in the following table.
ft~,1 PF ed
c.::,
b
'2.
)
os
c..
~.'( ~
S'
,'~:: ~.~- ~.
9-\1' IA£>
J
lA,
~ ~,\-V"W J
3-3