Ice Machine Adjustments - Scotsman NU150 Service Manual

NU Undercounter Ice Machine Service Manual

Ice machine adjustments

Adjustment of ice thickness
The ice thickness has been adjusted to a
suitable position before it was shipped out. If
needed, adjust the screw on the ice thickness
sensor properly to meet the suitable thickness.
Clockwise rotation can make the ice thickness
thicker, while counterclockwise can make the
ice thickness thinner.
Note：
When adjusting the screw on the ice thickness
sensor, do not adjust too much, 1 laps per time
or so; after three cycles, if the ice thickness still
cannot meet the requirements, adjust it again.
The ice thickness could be adjusted to a
required level by this mean.
Drainage adjustment
The adjustment of the drainage number of the
ice machine depends on the local water quality
and water cleanliness.
Recommendation：
To obtain a higher degree of transparency ice
and to maintain the cleanliness of the sink,
recommends that the drainage is set behind
one ice making cycle, this is the factory setting.
Thicker
14
Adjustments