Appendices; Key Action; Save And Load A Setting; Error Messages - ANDILOG CENTOR EASY Operating Manual

VII.

Appendices

1. Key action

Button Measure Mode
ON/Off Turn On & Off your device
M Access to the menu mode
O Backlight
X
Inactive
MAX Change the value displayed on
line 2
TDX Send data through RS232 or
save data to the STAT mode
UNIT Change the measurement unit
ZERO Zeroing the force gauge

Save and load a setting

2.
You can store a configuration, and reload it at any time. To do so, press the M key to go to the Menu
mode then:
•
Press ZERO and M to save the configuration
•
Press TDX and M to reload the saved configuration
•
Press X and M to load the factory configuration

3. Error Messages

The AUTOTEST screen displays if:
•
The device detects a minor or major default when it starts
•
In the SYSTEM sub menu, by pressing the keys: M and MAX
a. Minor defaults
•
Low battery level
•
Calibration is due
•
Backup battery is out of order
Press the MAX key to continue
b. Major defaults
•
Load cell is out of order: "Off" value is higher than 3%
•
Counter of overload reach its maximum value: "OVERL" value is higher than 10
•
Internal error
Please contact ANDILOG
CENTOR EASY Force Gauge
Menu Mode
Turn On & Off your device
Exit and Save
Backlight
Exit without saving
Up
Right
Down
Left
- 17 -
Operating Manual – V3.39