Subscribe to Our Youtube Channel
Related Manuals for jobmate JMCMT18G.9
Summary of Contents for jobmate JMCMT18G.9
- Page 1 SAFETY AND OPERATING MANUAL LI-ION OSCILLATING MULTI TOOL SKIN ONLY JMCMT18G.9...
-
Page 2: General Power Tool Safety Warnings
GENERAL POWER TOOL use common sense when operating a power tool. Do not use a power tool while you are SAFETY WARNINGS tired or under the influence of drugs, alcohol or medication. A moment of inattention while WARNING! Read all safety warnings and all operating power tools may result in serious instructions. -
Page 3: Safety Warnings For Battery Pack
starting the power tool accidentally. or temperature above 130 °C may cause explosion. d) Store idle power tools out of the reach of children and do not allow persons unfamiliar g) Follow all charging instructions and do not charge the battery pack or tool outside with the power tool or these instructions to operate the power tool. -
Page 4: Additional Safety Instructions For Your Battery Charger
water and seek medical advice. they do not play with the appliance. f) Seek medical advice immediately if a cell or If the supply cord is damaged, it must be battery pack has been swallowed. replaced by the manufacturer, its service g) Keep battery pack clean and dry. - Page 5 SYMBOLS ABN: Australian Business Number. By this number, business information such as entity type, status, business location etc. can be found at website To reduce the risk of injury, user must http:/ /abr.business.gov.au. read instruction manual ABN of Positec Australia Pty Limited is 14 101 682 Warning Wear ear protection Wear eye protection...
-
Page 7: Component List
COMPONENT LIST 1. On/Off switch 2. Battery pack release button* 3. Battery pack* 4. Variable speed control 5. Venting slot 6. Flange 7. Allen key 8. Sanding plate ＊Not all the accessories illustrated or described are included in standard delivery. ACCESSORIES 1-1/8”... -
Page 8: Operation Instructions
OPERATION INSTRUCTIONS NOTE: Before using the tool, read the instruction book carefully. INTENDED USE The power tool is intended for sawing and separating wooden materials, plastic, plaster, non-ferrous metals and fasteners (e.g. nails and clamps) as well as working on soft wall tiles and for dry grinding of small surfaces. -
Page 9: Installing And Removing The Battery Pack
Fig.A INSTALLING AND REMOVING THE BATTERY PACK A) TO REMOVE THE BATTERY PACK (SEE FIG. B1) Depress the Battery Pack Release Button (2) firmly first and then slide the Battery Pack out from your tool. B) TO INSTALL THE BATTERY PACK (SEE FIG. B2) Slide the fully charged Battery Pack onto the tool with sufficient force until it clicks into position. - Page 10 Fig.C2 5. USING THE VARIABLE SPEED CONTROL (SEE FIG. F) Select oscillation frequency (speed) while the motor is running. The variable speed control (4) can be used to set the optimum oscillating frequency according to the accessories used and the respective application. High oscillation frequency: Sanding, sawing, rasping and polishing stone and metal.
-
Page 11: Working Hints For Your Tool
Fig.F 9. SCRAPING Typical application: Scraping off old varnish or adhesives, removing glued carpeting, e. g. on stairs or other small to medium-sized surfaces. Select medium / high oscillation frequency. WORKING HINTS FOR YOUR TOOL If your power tool becomes too hot, especially when used at low speed, set the speed to maximum and run it with no load Fig.G for 2-3 minutes to cool the motor.
Need help?
Do you have a question about the JMCMT18G.9 and is the answer not in the manual?
Questions and answers