Setup After Transporting - In-Step Mobility U-Step 2 Walking Stabilizer Step-By-Step Manual

4) Hold the U-Step 2
by the side to place it
into your vehicle.
G. Setup After Transporting
1) Release the locking clip holding
the U-Step 2 in the folded position.
2) Allow the U-Step 2 to open –
with the base on the ground.
3) Press the seat down in the
middle until the Release Lever
snaps into place.
SAFETY NOTE:
seat down until the Release Lever fully snaps into place.
— 8 —
3) Secure the locking clip to
stop the walker from folding.
Simply rotate the clip until it at-
taches to the backrest tube.
It is very important to press the