Http://Www.xiaoyu163.Com - Yamaha EMX 620 Service Manual

Hide thumbs Also See for EMX 620:

Owner's manual (18 pages)

Table Of Contents

Table of Contents

3 7 63 1515 0

2-4 Gain

Each output gain should be as shown in the table below.

Table1

Input Terminal

Lo-Z

Hi-Z

LINE

INST

AUX IN

TAPE IN

2-5 Frequency Response

When the input signal frequency is set to 20 Hz and 20 kHz for the systems shown in table 1, the each output terminal should fall within

the range of +1 and -3 dB at 20 Hz and 20kHz, using 1 kHz as the reference.

2-6 Equalizer Characteristics

When the input signals shown below are applied to the channel input the states of 2-3 and the channel EQ (HIGH, LOW) level control

are changed from center position (flat), the boost/cut range at the MAIN OUT should be as follows:

Table 2

EQ Controls

L 13942296513

LOW

HIGH

If the result of the equalizer is out of the specified range, change the input signal frequency so that the output signal is at the set

level. Its frequency should then be within the range of 80 - 120% of the standard frequency.

2-7 Graphic Equalizer Characteristics

When the input signals shown below are applied to the channel input in the states of 2-3 and graphic equalizer level control are changed

from center position (flat), the boost/cut range at the MAIN OUT and the MONITOR OUT should be as follows:

Table 3

Maximum

Response

Minimum

If the result of the graphic equalizer is out of the specified range, change the input signal frequency so that the output signal is at the set

level. Its frequency should then be within the range of 80 -120% of the standard frequency.

www