Table of Contents
Advertisement
Tool operators and maintenance personnel must always
comply with the safety precautions given in this manual,
and on the stickers and tags attached to or on the tool
and hoses.
These safety precautions are for your safety. Review
them carefully before operating the tool or performing
any maintenance or repairs.
Supervising
personnel
precautions for your work area to comply with company
policies and local safety regulations. Enter any added
precautions in the space provided in this manual.
The CD12 Hydraulic Core Drill will provide safe and
dependable service if operated in accordance with the
instructions given in this manual. Read and understand
this manual and any stickers and tags attached to the
tool and hoses before operation. Failure to do so could
result in personal injury or equipment damage.
•
Operator must start in a work area without
bystanders. Flying debris can cause serious injury.
•
The operator must be familiar with all prohibited work
areas such as excessive slopes and dangerous
terrain conditions.
•
Establish a training program for all operators to
ensure safe operations.
•
Do not operate the tool unless thoroughly trained or
under the supervision of an instructor.
•
Always wear safety equipment such as goggles,
head protection and safety shoes at all times when
operating the tool.
•
Do not inspect or clean the tool while the hydraulic
power source is connected. Accidental engagement
of the tool can cause serious injury.
•
Do not operate this tool without first reading the
Operating Instructions.
•
Never operate the tool if you cannot be sure that
underground utilities are not present. Underground
electrical utilities present an electrocution hazard.
Underground gas utilities present an explosion
hazard. Other underground utilities may present
other hazards.
•
Do not wear loose fitting clothing when operating the
tool. Loose fitting clothing can get entangled with the
tool and cause serious injury.
SAFETY PRECAUTIONS
may
specify
additional
•
Supply hoses must have a minimum working
pressure rating of 2500 psi/175 bar.
•
Be sure all hose connections are tight.
•
The hydraulic circuit control valve must be in the
OFF position when coupling or uncoupling the tool.
Wipe all couplers clean before connecting. Failure
to do so may result in damage to the quick couplers
and cause overheating. Use only lint-free cloths.
•
Do not operate the tool at oil temperatures above
140 °F/60 °C. Operation at higher oil temperatures
can cause operator discomfort and may cause
damage to the tool.
•
Do not operate a damaged, improperly adjusted or
incompletely assembled tool.
•
To avoid personal injury or equipment damage,
all tool repair, maintenance and service must only
be performed by authorized and properly trained
personnel.
•
Do not exceed the rated limits of the tool or use the
tool for applications beyond its design capacity.
•
Always keep critical tool markings, such as labels
and warning stickers, legible.
•
Always replace parts with replacement parts
recommended by STANLEY.
•
Check fastener tightness often and before each use
daily.
•
WARNING: Some dust created by power sanding,
sawing, grinding, drilling, and other construction
activities contains chemicals known to the State
of California to cause cancer, birth defects or
other reproductive harm. Some examples of these
chemicals are:
•
Lead from lead-based paints,
•
crystalline silica from bricks and cement
and other masonry products, and
•
arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
Protect yourself and those around you. Research
and understand the materials you are cutting.
Follow correct safety procedures and comply with
all applicable national, state or provisional health
and safety regulations relating to them, including,
if appropriate arranging for the safe disposal of the
materials by a qualified person.
CD12 User Manual ◄ 5
Advertisement
Table of Contents
