Table of Contents
Advertisement
Engine Installation
3-1.2. Engine Receipt and Handling
NOTE: The engine is preserved for long term storage at factory; if it is not
immediately installed after acceptance, refer to "Engine Preservation and
Storage" instructions in Chapter 9 of M-0, Standard Practice Maintenance
Manual, for ongoing corrosion protection instructions. Environmental
conditions (humidity), seasonal changes, and engine usage influence
susceptibility to corrosion. Owner/operator is responsible for recognizing
risk of corrosion and taking appropriate precautions.
When the engine arrives, inspect the crating for damage. If the engine crating appears
damaged, notify the freight shipping company for resolution. If the crating appears intact,
proceed to Section 3-1.2.1.
3-1.2.1. Uncrating the Engine
1. Remove the lag screws attaching the wooden cover to the base.
2. Lift the wooden cover and remove it.
3. Open the plastic bag wrapped around the engine.
4. Locate and inspect the desiccant bag through the plastic shipping bag. Desiccant bag
is attached to the engine mount at the rear of the engine.
5. Inspect the engine according to the "Acceptance Inspection" criteria in Section 3-
1.2.3.
NOTE: The engine is preserved for long term storage at the factory; if it is
not immediately installed after acceptance, refer to the "Engine
Preservation and Storage" instructions in Chapter 9 of M-0, Standard
Practice Maintenance Manual for ongoing corrosion protection
instructions. Environmental conditions (humidity), seasonal changes, and
engine usage influence susceptibility to corrosion. In areas of high
humidity, corrosion can occur within two days of uncrating the engine.
The owner/operator is responsible for recognizing the risk of corrosion
and taking the appropriate precautions.
6. If the engine will be stored for any length of time, refer to the "Engine Preservation
and Storage" instructions in Chapter 9 of M-0, Standard Practice Maintenance
Manual.
3-1.2.2. Crating an Engine for Shipping
1. Lower the engine onto the container base.
2. Attach the engine using shock mounts and bolts.
3. Cover the engine with a plastic bag.
4. Install and attach the container cover to the base.
3-2
O-200-D & X Series Engine Installation and Operation Manual
3 January 2017
Advertisement
Table of Contents
