Panduit TERMINAL BLOCK MARKERS Quick Start Manual

TERMINAL BLOCK MARKERS
Required Components
TDP43ME Printer with roll TDP43ME-TB-KIT
stand (TDP43ME-RS) and Width Guide Adapter Kit
resin ribbon
step 1:
tdp43me f irmware update
• To print terminal block markers you must have TDP43ME printer firmware version
G3.0AP1 or newer
• To check version, press and hold the FEED button while turning the printer on. Keep
holding FEED until first 3 beeps, then let go of button.
• Self-test will print automatically, showing version number next to "TDP43ME"
(For more details see section 3-3 of TDP43ME user manual)
• If you have version G3.0AP0 or newer, proceed to step 2 below
• To upgrade your firmware, visit www.panduit.com/FirmwareUpdate
• Open the downloaded .zip file, and doubleclick on the DownloadTool 1.7.0.0f.exe file
• Click on Download Firmware
• Click on the .BIN file to highlight and select
• Click Open, printer should automatically begin firmware installation and reboot
Contact Panduit Identification Technical Support with any questions.
GA-TechSupport@panduit.com | 866-871-4571
step 2:
INSTALL EASY-MARK PLUS
If you have already installed Easy-Mark Plus
Existing Easy-Mark users:
TM
- Visit www.panduit.com for a free upgrade to Easy-Mark Plus
New Easy-Mark users:
TM
- Install Easy-Mark Plus that is provided with your TDP43ME printer
TM

quick start guide

Easy-Mark Plus
TM
Labeling Software
labeling software
tm
Labeling Software, then proceed to Step 3.
TM
TM
step 3:
Width guide Installation
1
Align right "R" width guide insert into
green printer guide as shown above
3
Repeat installation for left "L" side
5
Use tabs on width guides to press
guides inward as needed
2
Use thumb to press insert horizontally
into guide, until insert snaps into place
4
Use fingers to widen guides
by pressing out
6
When changing from terminal block mark-
ers to other types of labels, use the rear
tabs on the width guide inserts to lift and
remove them from the green printer guides