Battery Installation; Charging - Samsung iDCS SLiM User Manual

BATTERY INSTALLATION

Before using the telephone it is important that you connect the battery to the con-
nector in the battery box. Assemble the battery cover as described below and
place the handset into the charger.
• Push the battery cover 5 mm towards the headset plug using your thumbs.
• Lift off battery cover.
• If the battery is not already installed, place battery plug in the slot in the bat-
tery box.
• Place the battery plug in the slot with red wire closest to the left (see Rear
View below).
• Insert battery with the label readable and replace cover.
Handset Rear View
It takes approximately 3 1/2 hours to charge the handset from fully discharged to
its full capacity. Place the handset in the charger. The display shows the charging
status in line 3. For correct charging the room temperature has to be between 0ºC
and 25ºC and therefore the handset must not be placed in direct sunshine. The
battery has a built-in heat sensor which will stop the charging if the battery tem-
perature is too high.
It is necessary to recharge the battery when the display shows "BATTERY LOW" , or
if it cannot be turned on. The LED flashes at a low frequency while charging and
lights constantly when the charging has finished.The display goes back to normal
mode when fully charged.
When the handset is placed in the charger the vibrator will not work and the B-
answer function is inactive even if chosen. If the battery is fully discharged, it will
be a moment before charging starts.
3 4

CHARGING