Table of Contents
Advertisement
Connecting to an External Source
GB
The auxiliary input can be used to take advantage of the
sound quality of your mini-compact system when listening to
other sources.
Examples:
A television
A video disc player
A Hi-Fi stereo video cassette recorder
To connect the external source, the source must have an audio
output. In addition, you need an RCA connection cable.
1
Set the system to standby mode and disconnect it and the external
source from the main.
2
Connect the audio cable to the rear of the mini-compact system.
Connect the...
Red jack
White jack
For optimum sound quality, do not invert the right and left
channels.
3
Plug the system back into the main socket and press On/Standby to
switch it on.
4
Select the AUX source by pressing AUX.
Result: AUX is displayed.
5
Switch the external source on.
6
Adjust the volume and balance as required:
Volume
Equalizer
Example: You can watch a film and take advantage of stereo sound
provided that the original sound track is in stereo (as if you
were in a cinema).
CD Digital Out Jack
This unit can output CD digital sound signals through this
jack. Use an optical cable to connect digital audio equipment.
(DAT deck, MD recorder, etc.).
Remove the dust cap (1) from the CD DIGITAL OUT jack. Then,
connect an optical cable plug to the CD DIGITAL OUT jack.
When the CD DIGITAL OUT jack is not being used
Attach the supplied dust cap.
8
To the connector marked...
R (right)
L (left)
R
L
R
L
AUX
IN
(1)
Connecting the Loudspeakers
The loudspeaker connector terminals are located on the rear
of the system.
There are four terminals on the system:
Two for the left speaker (marked L)
Two for the right speaker (marked R)
To achieve the correct sound quality, connect the:
Red wire to the + terminals
Black wire to the – terminals
1
To connect a wire to a terminal, push the tab as far as it will go:
To the right on the system
2
Insert the wire, up to the plastic sheathing, in the hole.
3
Push the tab back:
To the left on the system, until it clicks into place
To the top on the loudspeaker
Result: The wire is pinched and held firmly in place.
4
Repeat the operation for each wire.
(Right Speaker)
DIGITAL OUT
(OPTICAL)
(–)
(+)
Directions in Installing Speaker
Installation in a place near heating apparatus, under direct lay of
light or with high humidity may cause performance degradation
of the speaker.
Do not install on the wall or on a high place of pole or other
unstable place to prevent any safety accident caused by falling
of the speaker.
Do not take the speaker apart from TV or computer monitor.
The speaker near the TV or computer monitor may influence the
quality of the screen display.
(Left Speaker)
FM (75 )
AM ANT.
SPEAKER
(6 )
R
L
R
L
AUX
IN
(+)
(–)
SPEAKER
(6 )
R
L
Advertisement
Table of Contents
