Spycentre Security 5817 Quick Start Manuals

SpyCentre.com Spy Shop - Since 1993

How to Charge the Battery:

Connect the audio recorder to a PC or USB power supply
•
2.5 hours to fully charge
•
A solid light will be present when the device is charging
•
Blinking light = Fully Charged
•

How to Record an audio file:

Near the top of the pen is a silver pen clip
•
Slide the clip down to Activate the device
•
Once finished slide the clip up to stop the recording
•
Wait 5 seconds before making another recording
•
NOTE: If the device runs out of power during the recording, it will finalize and save the file before the battery dies
•

How to Playback files on the Device:

While the device is OFF, plug in headphones into the Remote control and connect to the AUX port on top of the Pen
•
Press the (>II) button on the remote control and first recorded file will begin to play
•
Navigate between files by using the (>>) and (<<) button
•
Solid light = Standby mode
•

How to Playback files on a PC:

Connect to the USB port of the computer
•
When connected the PC will recognize the device as a removable disk
•
Open VOICE folder
•
Double click the file you wish to play
•

How to Delete the files on a PC:

Open the VOICE folder
•
Right click on the file you wish to delete and select Delete in the pop up menu
•

How to Delete the files on a Mac

Open the VOICE folder
•
Right click on the file you wish to delete and select Delete in the pop up menu
•
While the device is still plugged into the Mac go to your trash folder and empty trash.
•
Note: If the above step is not completed the files will not be fully deleted from the device and you will have a phantom
•
folder that will contain the deleted files that can only be seen by a Windows Computer

How to set Recording Quality on device:

While the device is OFF, plug in headphones to the Remote control and connect to the AUX port on the top of the Pen
•
There are 3 recording qualities. LP, HQ, XHQ
•
To change the quality press and HOLD the (M) button for 3 seconds
•
Depending on the device a beep noise, or light may light up on the device
•
BEEP NOISE: 1 beep = XHQ , 2 beep = HQ, 3 beep = LP
•
LIGHTS: Blue = XHQ , Green = HQ , Red = LP
•
You can listen to the differences in quality by starting a new recording file with the headphones plugged in
•

How to Set Voice Activation on Device:

While the device is OFF, plug in headphones to the Remote control and connect to the AUX port on top of the Pen
•
Press the ([]) stop button and a light will be visible on the pen
•
Press the ([]) stop button again to change between Voice activation, and Continuous recording
•
A solid light = Voice activation ON
•
A blinking light = Voice activation OFF
•
To save your mode create a new recording file
•
SLEEK AUDIO RECORDER PEN
Monday - Saturday 10AM to 6PM CST

QUICK START GUIDE

Toll Free # 1-800-292-7748