Connecting The Fm Antenna; Before Using Your Home Theater - Samsung HT-THQ22 Instruction Manual

Connecting the FM Antenna

FM Antenna (supplied)
1
Connect the FM antenna supplied to the FM 75Ω COAXIAL terminal.
2
Slowly move the antenna wire around until you find a location where reception is good,
then fasten it to a wall or other rigid surface.
•
This unit does not receive AM broadcasts.
Note
The cooling fan supplies cool air to the unit to prevent overheating.
Cooling Fan
Please observe the following cautions for your safety.
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
• Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
19

Before Using Your Home Theater

Your Home Theater is capable of playing DVD, VCD, CD, MP3/WMA and JPEG discs.Depending on the disc
you are using, these instructions may vary slightly. Read the instructions carefully before using.
To Operate your Samsung TV and the Home Theater with the HT-THQ22/HT-THQ25's Remote Control
1
Plug the main unit's power cord into the AC power supply.
2
Press TV button to set the remote to TV mode.
3
Press the POWER button to turn on your Samsung TV
with this remote.
4
Press TV/VIDEO button to select VIDEO mode on your TV.
5
Press DVD RECEIVER button to switch to DVD RECEIV-
ER mode.
6
Press FUNCTION button on the main unit or DVD button
on the remote to enable DVD/CD playback.
Selecting the Video Format
Press and hold NT/PAL button on the remote controller for over 5 seconds
while the power is turned off.
•
By default, the video format is set to "PAL".
•
"NTSC" or "PAL" will appear in the display. At this time, press the NT/PAL button
shortly to select between "NTSC" and "PAL".
•
Each country has a different video format standard.
•
For normal playback, the video format of the disc must be the same as the video
format of your TV.
•
Buttons Enabled for TV Operation: POWER, CHANNEL, VOLUME, TV/VIDEO, and Numeric (0-9) buttons.
Note
•
By default, the remote control is set to work with Samsung TVs.
See page 67 for more information about remote control operation with other manufacturer's TVs.
GB
20