OPERATING INSTRUCTIONS Contents The operating instructions contain important information. Operating Instructions ............... 2 ▶ Read the operating instructions carefully and follow the safety instruc- Authorized use .................. 3 tions in particular, and also observe the operating conditions. ▶ Operating instructions must be available to each user. Basic safety instructions ..............
BASIC SAFETY INSTRUCTIONS These safety instructions do not make allowance for any Non-authorized use of the solenoid valve type 5282 may be a • contingencies and events which may arise during the installation, hazard to people, nearby equipment and the environment.
Page 4
▶ The enclosed UL instructions must be followed in the UL area. The operating instructions and data sheets for type 5282 can be found ▶ Do not put any loads on the body (e.g. by placing objects on it or standing on it).
TECHNICAL DATA 4.2 Application conditions Ambient temperature: max. +55 °C Operating conditions The following values must also be observed for valves with UL/UR The following values* are indicated on the type label: approval: • Voltage (tolerance ± 10 %) / current type Seal materials •...
Page 6
4.3 Conformity Permitted medium temperature and permitted media depending on seal material: Type 5282 conforms with the EU Directives according to the EU Decla- ration of Conformity. Seal Medium Permitted media material temperature 0 °C ... +90 °C Per-solutions, hot oils without additives, 4.4 Standards...
INSTALLATION 5.2 Before installation Installation position: Safety instructions Installation can be in any position. DANGER! Preferably: Actuator upright. → Prior to installation check pipelines for dirt and, if required, clean. Risk of injury from high pressure in the equipment. ▶ Before loosening the pipes and valves, turn off the pressure and Dirt filter: To ensure that the solenoid valve func- vent the pipes.
Page 8
5.4 Manual emergency actuation 5.5 Changing valve function NOTE! (not possible for var Code CF02 and MT50) max. 2.0 Nm Caution! • When the manual emergency actuation is locked, the valve can no longer be actuated electrically. Pilot valve Manual emergency actuation O-rings Press...
Page 9
CAUTION! Function NC Function NO The pilot valve is The pilot valve is Discharge of medium if the throttle screws are unscrewed too far. installed in such a installed in such a way that the manual way that the manual emergency actuation emergency actuation points in the direction...
Page 10
Electrical connection of the cable plug Note the voltage and current type as specified on the type label. DANGER! Risk of injury due to electrical shock. → Tighten cable plug (for permitted types see data sheet), observing ▶ Before reaching into the device / equipment switch off the power max.
MAINTENANCE, TROUBLESHOOTING Procedure: → Pulse valves (variable code CF 02) as in “Fig. 8: Circuit diagram” Safety instructions connect. Pulse to Terminal 1 closes the valve; pulse to Terminal 2 DANGER! opens the valve. → Connect standard version L1/+ or N/– to Terminals 1 and 2 irre- Risk of injury from high pressure in the equipment.
SPARE PARTS 6.2 Malfunctions If malfunctions occur, check whether: CAUTION! → the device has been installed according to the instructions, Risk of injury and/or damage by the use of incorrect parts! → the electrical and fluid connections are correct, Incorrect accessories and unsuitable spare parts may cause injuries →...
TRANSPORT, STORAGE, DISPOSAL Exploded drawing NOTE! Transport damages. Pilot valve Inadequately protected equipment may be damaged during transport. • During transportation protect the device against wet and dirt in shock-resistant packaging. • Avoid exceeding or dropping below the allowable storage temperature.
Need help?
Do you have a question about the 5282 and is the answer not in the manual?
Questions and answers