R The installation shall be carried out in accordance with all applicable installation rules. R To the maximum extent permitted by law, Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or...
metal objects nearby. This may reduce the Important safety information range where the hearing aid has good audibility. – Do not install or use the product in health To prevent severe injury or loss of life or property, care facilities if any regulations posted in the and to ensure proper and safe operation of your area instruct you not to do so.
Supplied accessories for installation For the main monitor Screw ´ 2 (4 mm ´ 16 mm) Mounting bracket ´ 1 Important: R You will need the following additional items to install and configure the main monitor. [Locally procured] – Wires: Prepare wires of the appropriate specification.
Precautions for installation R This product is a bus-powered main monitor for use with Panasonic Video Intercom Systems. Power is supplied from a lobby station or distributor. R Do not install the product in the following locations. There may be a risk of malfunction or communication disturbances.
Page 5
Wire type and length Wire type Wiring run Diameter Max. length Connected device ø 0.65 mm (22 AWG) approx. 100 m « (example: lobby Main monitor ø 1.2 mm (17 AWG) approx. 200 m station or distributor) According to ø 0.5 mm - ø 1.2 mm «...
Main monitor installation Installing the main monitor position Attach the mounting bracket (A) to the wall securely. About the installation position of the main R Install the mounting bracket on a vertical flat monitor and mounting bracket wall (B). R Place the main monitor in a location that your eyes are the same height as the centre of the display.
Page 7
Important: R Do not connect the power cable. (Damage may occur.) Mount the main monitor to the mounting bracket. 3-1 Line up the tab on the bottom of the bracket with the groove on the main monitor. 3-2 Line up the tab on the top of the bracket with the groove on the main monitor, and push the main monitor down until it is secure.