Logic - MDT BE-02001.01 Technical Manual

Technical Manual Universal Interface BE

4.6. Logic

The universal interface contains of 4 individually switchable and parameterize able logic blocks. At
the following page, the logic blocks can be activated and the general settings can be made:
Figure 21: Activation logic blocks
The following parameter can be adjusted once and is valid for all of the 4 logic blocks:
Sub-function
Behavior at bus power up
Table 40: Common Parameter logic blocks
If the read of the external logic at bus power up is activated, the status of all external logic objects
will be read at a bus power up. So the logic operation is evaluated new. If this function is not active,
the universal interface will hold the status before bus power outage.
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
42
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[default value]

no read ext. logic objects

read ext. logic objects
comment
sub-function indicates whether the
external logic objects should be read or
not at a bus power up