Table of Contents
Advertisement
Technical Manual Universal Interface BE
The setting option 2 Bit value (forced setting) has the following options to parameterize this function:
ETS-text
Send forced setting at
rising/falling edge
Table 22: Dynamic range send value-forced setting
The forced setting object allows for example to control the automatic brightness control of presence
detectors.
The forced setting object can send 3 different states:
Forced setting not active (control=0; value=0)
The forced setting object has no influence on the receiver. For example at a presence
detector, the automatic function (motion detector operation) would be switched on.
Forced setting off (control=1; value=0)
The forced setting object switches the receiver unconditionally off. For example a presence
detector, would be switched permanent off. Detected motions have no influence on the
output.
Forced setting on (control=1, value=1)
The forced setting object switches the receiver unconditionally on. For example a presence
detector, would be switched permanent on. Detected motions have no influence on the
output.
The according communication object is shown at the chart:
Number
Name
0
Send forced setting
Table 23: Communication object Send value-forced setting
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
29
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[default value]
Forced setting not active
Forced setting off
Forced setting on
Length
Usage
2 Bit
sends the adjusted forced setting
comment
Assignment, which forced
setting should be send at which
edge
Advertisement
Table of Contents
