Napoleon LHD45 Installation Instructions

BATTERY BACK-UP INSTALLATION INSTRUCTIONS

ALLOW SAFETY SCREEN TO COOL COMPLETELY BEFORE ANY MAINTENANCE AS IT WILL REMAIN HOT
ENSURE THE UNIT IS COMPLETELY COOL BEFORE STARTING INSTALLATION.
TO AVOID DANGER OF SUFFOCATION KEEP THE PACKAGING BAG AWAY FROM BABIES AND
CHILDREN. DO NOT USE IN CRIBS, BED, CARRIAGES OR PLAY PENS. THIS BAG IS NOT A TOY.
NOTE: In the event of a power failure your appliance can be operated using the battery back-up supplied.
A. Turn the gas and electrical power off to the appliance, before begining installation.
B. Locate the battery housing supplied in the manual baggie.
C. Install four "AA" batteries into the battery housing, ensure the positive and negative ends correspond with those
identifi ed on the holder. (To open the battery housing slide the back piece upwards and off of the battery housing).
D. Remove the surround equipped with the safety screen then remove the trim to easily access the control
compartment, as shown below.
E. Attach the wire labelled "BATTERY" from the wiring harness, located in the control compartment of the appliance,
to the battery housing.
F. Place the battery housing into the control compartment, ensure that the battery housing is placed in a clean and
easily accessible location.
G. Reinstall the trim then the surround equipped with the safety screen. The surround must be installed at all times
during appliance operation.
H. Turn the gas and electrical power back on to begin operating the appliance.
NOTE: Once the power has been restored remove the batteries from the holder. The system will drain the
batteries if they are left in the battery holder.
LEFT BRACKET
SHOWN
TO VIEW A VIDEO OF THIS INSTALLATION VISIT OUR WEBSITE AT: www.napoleonfi replaces.com/productsupport/
NOTE: FOR MORE DETAILED INSTRUCTIONS REFER TO YOUR INSTALLATION MANUAL.
LHD45
WARNING
!
DO NOT TOUCH SAFETY SCREEN UNTIL COOLED.
AFTER APPLIANCE IS NO LONGER OPERATING.
KNOT BEFORE THROWING AWAY.
!
06.03.14