Table of Contents
Advertisement
Functional Description
MD Dwell Time : When was motion detection in each preset that have established
motion detection function, it set time that keep relevant preset.
For detailed settings of the Motion Detection for each Preset
menu, see page 42 and 43.
Alarm Setting
Output Clear
Input 1
OFF
Input 2
OFF
Output
OFF
Enable
OFF
MD Dwell Time
OFF 30 SEC
ON/OFF : It can be set up how long the operation will be kept when the motion is
detected. (1-59 sec, 1-59 min)
6) Initialize
•
Initialization Menu
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Status
Power On Reset : Camera is initialized into the original status of power input.
Initial Position : If you want to set the default direction of the camera so that the
camera faces that direction when the power is turned on, you
can set up the desired Pan and Tilt for the camera.
56
Alarm Setting
Output Clear
Input 1
OFF
Input 2
OFF
Output
OFF
Enable
OFF
MD Dwell Time
ON 30 SEC
Initialize
Power ON Reset
Initial Position
Factory Default Set
Camera Default Set
Auto Refresh
OFF
Factory Default Settings : Camera is initialized into the factory default settings.
Data including Preset is deleted. This function is used
for initialization all settings.
Camera Default Settings : If only the camera module is replaced due to camera
module failure, the new camera module can be set up
with the settings of the old camera module.
Auto Refresh : The electric circuit and the status of the equipment parts within
the camera are optimized regularly. (The cycle can be set up.) If
camera faces toward a certain source of light or if the settings
cannot be kept because of the long time rotation filming of a
certain area, the Auto Refresh function is used to maintain and re-
set the existing camera settings. Default setting is OFF.
OFF, 1-7 Days : This function is disabled in the OFF mode. 1-7 Days enables the
Auto Refresh operation in the interval of the selected days. Auto
Refresh takes less than 10 seconds. The message "Auto Refresh"
disappears after finishing the operation.
7) Status
The status of dome camera setting is displayed.
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Status
Cam Model = 10NC
Cam Version = 4.6
Dome Version = 1.00
Dome ID=001
Controller=Duplex-9600
Camera Status
CAM MODER
= 10NC
CAM VERSION
= 4.6
DOME VERSION
= 1.00
CON PROTOCOL
= SAMSUNG TW
DOME ID
= 001
CONTROLLER
= Duplex-9600
Camera Model
Camera S/W Version
Control Board S/W Version
Dome Camera ID
Communication Mode Setup
57
Advertisement
Table of Contents
