NETGEAR APS150W Installation Instructions

Installation
NETGEAR Power Supplies Units for
Managed Switches
APS150W, APS250W, APS550W, APS1000W, APS600W,
and APS1200W

Package Contents

Power Supply Unit Overview
The following table provides an overview of the power supply units (PSUs)
for managed switches and the models in which they are supported.
PSU Model Used in Switch Model
APS150W M4300-28G
M4300-52G
AC OK LED. All PSUs provide one AC
APS250W M4300-8X8F
OK LED. During normal operation, this
LED lights green to indicate that the
M4300-12X12F
PSU is receiving power.
M4300-24X24F
DC OK LED. Model APS150W also
APS550W M4300-28G-POE+ provides one DC OK LED. During
normal operation, this LED lights green
M4300-52G-POE+
to indicate that the DC outputs are
within regulation limits.
APS1000W M4300-28G-POE+
M4300-52G-POE+
M6100-3S
RPS4000v2
APS600W M4300-96X
APS1200W M4300-96X
Install an Additional Power Supply Unit
In models with more than one power supply bay, you can install an
additional PSU.
¾ To install an additional PSU:
1. Pull out the cover plate from the power module bay in which you want
to insert the additional PSU.
2. Insert the additional PSU into the power module bay, and gently push
the PSU into the bay.
When inserting the PSU, do not use unnecessary force. Doing so
CAUTION:
can damage the connectors on the back of the PSU and on the midplane.
3. Connect the end of the power cord to the power receptacle on the PSU.
4. Plug the AC power cord into a power source such as a wall socket or power
strip.
When you apply power, both the AC OK LED on the PSU and the switch's
Power LED that is associated with the power supply bay light. If these LEDs
do not light, make sure that the power cord is plugged in correctly and that
the power source is good.
Replace a Power Supply Unit
In models with more than one PSU, the PSUs are hot-pluggable.
¾ To replace a PSU:
1. If your switch functions with a single PSU only, disconnect the power cord
from the PSU and let the switch power down.
If your switch functions with more than one PSU, you do not need to power
down the switch and you can perform a hot swap.
2. Remove the PSU from the power module bay by moving the orange release
latch to the left and pulling the extraction handle.