NETGEAR, Inc. Technical Support Thank you for choosing NETGEAR. To register your product, get the latest product updates, or get support online, visit us at http://support.netgear.com.
NETGEAR 8800 Series switches. This note applies only to the 8800 Series 100-240VAC PSU. For detailed information about NETGEAR switches and all of their compatible PSUs, see the product data sheets available online at www.netgear.com.
Page 5
Download zur Verfügung: www.netgear.com. WARNING! NETGEAR 8800 Series 100-240VAC PSUs do not have switches for turning the unit on and off. Remove the wall plug from the electrical outlet to disconnect the power to an 8800 Series 100-240VAC PSU. Ensure that this connection is easily accessible.
8800 Series 100-240VAC PSU XCM88PS1 Installation Guide Power Supply Cords The following power supply cords are provided in the package with the PSU: Table 1. Power supply cords Model Product Name Region 10041 Power cord, 10A, NEMA 5-15P, IEC320-C13, Right Angle North America...
8800 Series 100-240VAC PSU XCM88PS1 Installation Guide Installing an 8800 Series 100-240VAC PSU CAUTION: Make sure that the PSU circuit is not overloaded. Use proper over-current protection, such as a circuit-breaker, to prevent over-current conditions. To install an 8800 Series 100-240VAC PSU: Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to the ground receptacle, at the top left corner of the switch front panel.
Page 8
8800 Series 100-240VAC PSU XCM88PS1 Installation Guide Figure 2. Installing a 8800 Series 100-240VAC PSU Secure the PSU by pushing down on the locking handle until it clicks into place. If you are replacing a power supply, you do not need to unplug the AC power cord. For a newly installed power supply, connect an appropriate AC power cord as follows: a.
8800 Series 100-240VAC PSU XCM88PS1 Installation Guide Removing an 8800 Series 100-240VAC PSU CAUTION: An operating AC PSU may be hot to the touch; use thermal protective gloves when handling the 8800 Series 100-240VAC PSU during removal. To remove a PSU: Attach an ESD-preventive wrist strap to your wrist.
8800 Series 100-240VAC PSU XCM88PS1 Installation Guide Front Panel LEDs The front panel of the 8800 Series 100-240VAC PSU provides status LEDs. The following table describes the operation of these LEDs. Table 2. 8800 Series 100-240VAC PSU Front Panel LEDs...
Page 11
8800 Series 100-240VAC PSU XCM88PS1 Installation Guide More PSUs are needed to support the load if the low-line power range is used to power the switch. The software determines the maximum available power required for the switch and enables the modules accordingly.