LANGER EMV-Technik ESA1 User Manual page 6

LANGER
DE-01728 Bannewitz
mail@langer-emv.de
EMV-Technik
www.langer-emv.com
Then pull the BZ23-1 shielding material over the poles from the back. Flexible magnetic strips are
attached to the edges of the shielding material. Press them against the edges of the ground plate
to ensure a conductive connection. Two magnetic strips are provided for the connector area: one is
fixed to the ground plate from the outside, the other one from the top. The front of the shielding
material can be opened and closed separately to ensure quick alternation between measuring and
modifying (Figure 6 to Figure 8).
Figure 6 Z23-1 shielding tent closed
Figure 7 Z23-1 shielding tent open
Figure 8 Z23-1 shielding tilted backwards
Attention!
The shielding material is made from a thin, extremely conductive fabric. Protect the
shielding material against high mechanical stress from sharp-edged or pointed objects, for
example! Fold the shielding material in accordance with the folding instructions contained in the
bag!
After closing, press the lower edge of
the front and the lower edge of the left
and right side of the shielding material
against the ground plate.
An uninterrupted connection between
the ground
material is crucial for an effective
shielding.
If the tent is set up as shown in
Figure 7, you can see two press
buttons at the upper front edge of the
shielding
around the front transverse bar.
You can tilt the whole tent backward
for ease of accessibility. The press
buttons stop the shielding material
from sliding down.
- 6 -
ESA1
plate and shielding
material. Secure these