Table of Contents
Advertisement
Section 4: Troubleshooting
WARNING:
If the Level Measurement System is located in a hazardous environment,
do not open the enclosure cover or make/break any electrical connections
without first disconnecting electrical power at the source. Ensure that the
wiring, electrical fittings and conduit connections conform to the electrical
codes for the specific location and hazard level.
4.1
Problem/Cause/Checks
Controller/meter Display Drifting:
May be water in cable causing short circuit; look for kink or damaged cable;
check for broken wires, loose or corroded connections, or obvious short
circuits;
With transmitter wires disconnected, resistance between red or black lead
and shield should not exceed 15 megohms.
Controller/meter Display Incorrect:
May be wrong transmitter connections; check wiring.
May be defective transmitter; check as above, replace transmitter.
May also be controller/meter problems, such as calibration.
4.2
Factory Assistance
AMETEK Drexelbrook can answer any questions about this, or
any Drexelbrook instrument. Call Customer Service at:
1-800-553-9092 (US and Canada) or
+1 215 674-1234 (International).
If you require assistance and attempts to locate the problem
have failed:
Contact your local Drexelbrook representative,
Telephone the Service department toll-free:
• 1-800-527-6297 (US and Canada)
• +1 215 674-1234 (International)
FAX: Service Department + 215-443-5117
E-Mail: drexelbrook.service@ametek.com
11
Troubleshooting
Advertisement
Table of Contents
