Checking The Water Dispenser Line - Samsung DA68-01453B Owner's Manual And Installation Instructions

CHECKING THE WATER DISPENSER LINE (OPTIONAL)
1) In order to operate the ice maker properly, water pressure of 1.4 ~ 10 kgf/cm
19.9 ~ 142.2 psi, 1.37 ~ 9.8 bars) is required.
In this range a 100 cc paper cup can be filled in 10 seconds.
2) The water filter removes particles. It does not sterilize or destroy any micro-organisms.
3) If the refrigerator is installed in an area with low water pressure (below 1.4kgf/cm
19.9 psi,1.37bars), you should install a booster pump to compensate for the low pressure.
4) Ensure the water storage tank inside the refrigerator is properly filled initially. Push the water dis
penser lever until the water runs from the outlet.
A universal water supply kit is available at extra cost from your dealer. The refrigerator manufacturer
recommends using a water supply kit containing copper tubing.
NOTE
Checking the Parts
Purifier
Tapping screw x 12EA
INSTALLING OF THE WATER DISPENSER LINE
(Case 1)
Connecting to water supply line
- Shut off the main water supply line and turn the Ice
maker to the off position.
- Locate the nearest cold drinking water line.
- Follow the instructions in the ice maker installation kit.
Water line
Clip A x 12EA
(Connector Water Filter Assy)
28
2 (0.14 ~ 9.8Mpa,
2 , 0.14 Mpa,
Valve water fitting
Sealing tape
1. Cold Water line
2. Pipe Clamp.
3.Copper (or Plastic) line
4.Compression Nut
5.Compression Sleeve
6.Shut Off Valve
7.Packing Nut.