SENSIT Technologies GOLD G2 Quick Start Instructions

HINT: As you approach the source of the
leak, continue pressing the "B" button to
slow down the tick if it is rapidly increasing.
If the tick is no longer heard press the "B"
button to reset. Pressing the "A" button
deactivates the tick.
IMPORTANT: When replacing
gooseneck into the clip on the right side,
wrap the gooseneck in a wide circular
manner counter-clockwise around the back
of the instrument. Bending in the opposite
direction may cause damage over the life of
the product.
WARNINGS:
To prevent ignition of flammable or combustible
atmospheres, disconnect power before servicing.
To reduce the risk of ignition of a flammable
atmosphere, batteries must only be changed in
an area known to be nonflammable.
Do not mix batteries of different age or type.
Not for use in atmospheres of oxygen greater
than 21%.
ONLY zero instrument in a gas free environment.
To maintain intrinsic safety, service must be
performed by factory authorized technicians
with approved replacement parts only.
851 Transport Drive
Valparaiso, IN 46383-8432
the
Innovative Detection Solutions
MADE IN THE USA
WITH GLOBALLY SOURCED COMPONENTS
Distributed by:
Phone: 219 465 2700
Web: www.gasleaksensors.com
Quick-Start Instructions
This is not a substitute for the
instruction manual. It is for
reference only.
Read and understand the
instruction manual before use.