Advertisement
9. Remove the drive gear from the housing.
10. Install the output shaft into the housing being sure to
lubricate the bearings with gear oil. Then install it onto
transmission with 4 bolts (2 top and 2 bottom) and torque
bolts to 48nm (35.4ft lbs). Make sure the shaft is not loose
and spins smoothly, if it is loose or too tight it will require
shimming.
IAG Performance | 1203 Baltimore Blvd. Westminster, MD 21157 | Ph: 410-840-3555 | www.iagperformance.com
7
Advertisement
