Advertisement
12. Install the drive gear into the housing and torque it to
25nm (18.1ft lbs).
13. Clean the sealer off of the transmission and housing
then clean both using brake cleaner. Next, using wheel
bearing grease install the clam shell bearings onto the
pinion shaft and re-install the diff making sure to plug in
the electrical connector. Apply sealer to the housing then
install it onto the transmission. Make sure to put bolts
back in proper locations or damage could be done to
transmission! Torque the housing bolts to 48nm (35.4ft
lbs). Then re-install shifter linkage and transmission cross
member.
IAG Performance | 1203 Baltimore Blvd. Westminster, MD 21157 | Ph: 410-840-3555 | www.iagperformance.com
10
Advertisement
