Repair And Service; Front Wheel Install - Batch Bicycles Cruiser Owner's Manual

Repair and Service

WARNING:
• Inspect the product frequently. Failure to inspect the product and to make repairs or
adjustments, as necessary, can result in injury to the rider or to others. Make sure all
parts are correctly assembled and adjusted as written in this manual and any "Special
Instructions".
• Immediately replace any damaged, missing, or badly worn parts with original
equipment.
• Make sure all fasteners are correctly tightened as written in this manual and any
"Special Instructions". Parts that are not tight enough can be lost or operate poorly. Over
tightened parts can be damaged. Make sure any replacement fasteners are the correct
size and type.
NOTE: Have a bicycle service shop make any repairs or adjustments for which you do not
have the correct tools or if the instructions in this manual or any "Special Instructions" are not
suffi cient for you.
16

Front Wheel Install:

WARNING:
A
• Do NOT use Axle Nuts without serrations to attach the front wheel.
• Ensure wheel spins freely without contacting fork or fender.
• Failure to obey these steps can allow the front wheel to loosen while riding. This can cause
injury to the rider or to others.
A
1. If the Axle Nuts are already attached to the front wheel axle, begin by removing
B
them and Shoulder Washers and set aside.
2. Set the wheel fully into the front fork Dropouts
B
3. Place a Shoulder Washer on each end of Axle with small shoulder facing IN as shown.
A
4. Install Axle Nuts with serrated surface facing IN.
5. With the wheel in the center of the fork and tighten both Axle Nuts securely.
C
A
B
C
9