Handlebar And Stem Installation - Batch Bicycles Cruiser Owner's Manual

Handlebar and Stem Installation

WARNINGS:
• To prevent steering system damage and possible loss of control, the "MIN-IN" (minimum
A
insertion) mark on the stem must be below the top of the Fork Locknut
• Ensure the Fork and Brake are pointing FORWARD before proceeding.
• Do not over tighten the stem bolt. Over tightening the stem bolt can damage the steering
system and cause loss of control.
• If the handlebar clamp in not tight enough, the handlebar can slip in the stem. This can
cause damage to the handlebar or stem, and can cause loss of control.
A
B
C
NOTE: Remove plastic Cap from the end of the Stem
needed.
1. Insert the Stem into the Fork Locknut
2. Align the Stem with the front tire and tighten the Stem Bolt
Stem, next section)
3. If necessary, loosen the Handlebar Clamp Bolt/Nut
comfortable riding position.
4. Tighten Handlebar Clamp Bolt/Nut
ing use.
10
B
F
E
D
C
D
. Loosen Stem Bolt
B
up to the top of the MIN-IN mark
E
securely (see Testing
F
and rotate Handlebar into a
F
securely so that Handlebar does not move dur-
Refl ector Installation (as equipped)
Refl ector Installation:
1. Position FRONT Refl ector
points straight forward.
.
2. Tighten Clamp Screw.
3. Position Seat Post Refl ector (if
B
equipped)
backwards.
4. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will
damage the Clamp.
E
as
A
.
A
so it
so it points straight
B
A
15