Made In Germany - Barthelme AQUALUC mini Instructions For Installation And Operation Manual

MADE IN
GERMANY.
AQUALUC mini
INSTRUCTIONS FOR INSTALLATION
AND OPERATION
Thank you for choosing this high-quality product from Barthelme!
1. GENERAL INFORMATION FOR INTENDED USE
Please read these instructions carefully prior to installation and initial operation of the LED lightline
and keep in a safe place. Should you pass this LED lightline on to a third party, please also include these
instructions.
This product is a high quality fl exible LED-luminaire with protection class IP67/68. Amongst other things,
it is resistant against fuel, acid, solvent, salt, humidity and abrasion. The high quantity of copper in the
circuit paths, the current limiter and the thermal conductive coating ensure high quality and a long lifetime.
The AQUALUC mini is only to be used for lighting purposes and may not be changed or modifi ed in any way
which is not described in these instructions. Non-observance of these instructions may inhibit the correct
functionality or cause damage to the product. In this case we do not assume any liability.
The minimum bending radius may not be exceeded and the lightline may not be bent,
Please observe the bending DIRECTION of the lightline (see illustration 2).
ATTENTION
The minimum bending radius of the AQUALUC mini is 5 cm.
otherwise the AQUALUC mini could be damaged!
Any warranty will be void in case of non-compliance.