Barthelme AQUALUC mini Instructions For Installation And Operation Manual page 13

If you use adhesive tape, please ensure that the surface to be taped is dry, even, and clean
(no fat, oil, silicone and dust particles). To achieve best adhesion, the surface of the AQUALUC
mini should also be clean (if necessary clean the surface of the LED lightline with a soft,
slightly damp cloth. To remove more severe stains use a standard cleansing material
without abrasive elements).
Fix the tape on the bottom side of the AQUALUC mini or on the mounting surface and press
the LED lightline fi rmly. The contact pressure should not exceed 10-15 N/cm
LEDs or the electronic parts of the AQUALUC mini could be damaged.
If you select the construction adhesive then it is important to ensure an even and slight
wave form distribution. The amount of adhesive used should be relative to the size of the
required adhesive surface.
• Individual length adjustment (optional):
To shorten the AQUALUC mini, the lightline may only be cut in a 90° angle, on the mar-
ked points (dashed line with scissors symbol), with a pair of scissors or cutting knife (see
illustration 3).
ATTENTION: in this case the AQUALUC mini loses its IP-rating IP67/68! To protect the open
end against moisture, you will need to seal it with the aid of the AQUALUC mini end cap
set (Art. 40100300). To do this, place the end cap on a fl at surface with the opening fa-
cing upward. Drizzle two drops of PU from the syringe into the end cap. Held vertically,
the open end of the AQUALUC mini should then be fi rmly pushed downward into the end
cap for at least 10 seconds. Displaced air and possible fl uid may escape from the side of
the end cap. The PU requires approx. 8 hours to fi rmly set. Only after this time may the
AQUALUC mini be further processed. A restoration of the IP-rating IP67/68 cannot be gua-
ranteed as this depends on the care and accuracy during the sealing process!
ILLUSTRATION 1:
PLEASE NOTE BEFORE INSTALLATION
The product should always be installed by two people in order to avoid a sagging of the
LED light line.
, otherwise the
2