Installation - LG LSP-340 User Manual

LGE CDMA Fixed Wireless Telephone
LSP-340

2.3 Installation

You should follow each step carefully as shown below in order to guarantee proper
operation of CDMA Fixed Wireless Telephone.
STEP I. Check Components
Fixed Wireless Terminal is supplied with the following standard unit and accessories;
1. LSP-340 Main Unit with Handset
2. Dipole Antenna
3. Backup Battery
4. User Guide
5. AC/DC Power Adapter
6. Power Cord(Only SMPS Adapter)
Please make sure that these components are present before you begin the unit
installation. And then compare the following figures and components. If components
are missing or damage is found, contact the store where you purchased the unit
immediately.
STEP II. Place the Terminal
Place the terminal on the stable flat secure surface area (desk, table, etc.). Serious
damage may result if the unit falls. Do not place the unit on, or within 1 meter of
heaters or radiators. This unit is designed for desktop usage. Avoid direct exposure to
the sun lights and damp area.
Read the SAFETY INFORMATION located at the first part of this document before you
place the terminal
STEP III. Connect Components (See the figures in "Installation Steps".)
Connect the antenna to the TNC antenna connector located at the top side of the
terminal. If you placed the terminal on the flat surface, bend the antenna up right.
Connect curl cord of handset assembly to the RJ-11C port located at the left side of
the terminal.
Open the battery case, securely connect the battery cord, place the backup battery
pack and close the case.
Connect the AC/DC Adapter cable to the DC input port located at the topside of the
terminal.
-. If it is good, beep tone is heard.
-. If it is not good(Booting is fail or beep tone is not heard), you have to connect the
adapter or backup battery, again.
Please follow the below to get better voice quality;
1. Keep away from electrical appliances such as TV, computer, radio and so on.
2. Keep terminal in a high and central location with no obstructions, such as metal
walls.
3. Raise the integral antenna of terminal to get maximum strength of receive signal
as shown figure at the next page.
-1EA-
-1EA-
-1EA-
. -1EA-
-1EA-
-1EA-
13