Installing Equipment - Toshiba TR1X426110 Owner's Manual

1) Each rail is connected to the enclosure with 6 screws (2 top, 2 middle, 2 bottom)
2) Remove the screws fastening each of the mounting rails to the enclosure as required.
3) Slide the mounting rails to the desired depth and reattach them using the screws you removed.
**The depth of the 2 PDU/Cable-Management Bracket can be adjusted using the same method.

Installing Equipment

11
WARNING: Do NOT install equipment until the enclosure has been stabilized.
heaviest equipment first and toward the bottom of the enclosure. Do NOT install from the top of
the enclosure. If using sliding rails, be careful when extending the rails. Do NOT extend more
than one set of sliding equipment rails at a time. Avoid extending sliding rails near the top of the
enclosure. Failure to follow these instructions can result in death, serious injury, or equipment
damage.
To install rack-mount equipment in the enclosure:
1) Refer to the equipment's manual for installation instructions.
2) The square holes at the middle of each rack unit are numbered. A single rack unit
includes the space occupied by the numbered hole and the holes directly above
and below.
Toshiba Rack Enclosure Installation Manual – 99881-000
Figure 10.1 – Mounting Rail
Figure 11.1 – Rack Unit / Numbered Holes
Install the
12