Advertisement
Overview - Parent unit
Zoom
CAM
Arrow keys
Light indicators
+ / VOL / -
MENU/SELECT
On/off
TALK
Basic operation - Baby unit
Adjust speaker volume
Turn off the baby unit
Press + / VOLUME / - to adjust your baby
Slide the ON/OFF switch to OFF to
unit speaker volume. It determines the
power off your baby unit.
lullaby volume and talkback volume
transmitted from your parent unit.
PATROL
LCD ON/OFF
Speaker
Power jack
Stand
Overview - Baby unit
Light sensor
Temperature
Infrared LEDs
sensor
Camera
ON/OFF light
+/VOLUME/-
Speaker
Microphone
ON/OFF slide
Night vision
The baby unit has infrared LEDs that
allow you to see your baby clearly at
night or in a dark room. When the baby
unit being viewed detects low light
levels, the infrared LEDs are switched
on automatically. The images from the
baby unit are in black and white, and
appears on the screen.
Notes
• It is normal if you see a short white glare
on your parent unit screen as the baby unit
is adapting to the dark environment.
• When the infrared LEDs are on, the images
are in black and white. This is normal.
Tip
• Depending on the surroundings and other
interfering factors, like lightings, objects,
colors and backgrounds, the display
resolution may vary. Adjust the baby unit's
angle or place the baby unit at a higher
level to prevent glare and blurry display.
Mount the baby unit (optional)
NOTE
Note
NOTES
If you drill the holes into a stud, go to step 3.
-OR-
• Check for reception strength and camera
If you drill the holes into an object other than a
angle before drilling the holes.
stud, insert the wall anchors into the holes. Tap
Use a pencil to mark two holes in parallel.
gently on the ends with a hammer until the wall
Make sure they are the same distance apart
anchors are flush with the wall.
as the wall mount holes on the baby unit.
Align the wall mount bracket and screws
Insert the screws into the holes and tighten
the screws until only 1/4 inch of the screws
with the holes in the wall as shown.
Tighten the screw in the middle hole first,
are exposed.
so that the wall mount bracket position is
fixed. You can tighten the other screw in
the top hole.
Place the baby unit on the wall mount bracket.
Place the baby unit on the wall mount bracket.
Tighten the screw into the threaded socket at
Tighten the screw into the threaded socket at the
the bottom to secure the baby unit.
bottom to secure the baby unit. Align the holes
on the wall mount bracket with the screws on the
wall, and slide the wall mount bracket down until
it locks into place.
For VM3251-2 only
Status check - Two baby units
If you are viewing baby unit
, the LINK LED light of baby unit
turns on.
As baby unit
is not being viewed, its LINK LED light flashes.
Note
NOTE
NOTES
• If you power on only one baby unit, your parent unit may display
and the LINK LED light flashes.
Press
to switch to the baby unit you have powered on.
Change different views - Single-cam
Press
to switch between the image of baby units
and
.
Press
.
Change different views - Patrol
Press PATROL to alternately view the image from baby units
and
every 10 seconds.
10s
Advertisement
