8
Table 1-1: Drive specifications (Continued)
Other information
Installation instructions
Parts required
To install this drive you will need:
• Parts supplied:
• rotary drive
• mounting foot
• spacing shims (x3)
• Additional parts:
• suitable securing bolts and lock washers/lock nuts (see
• suitable sprockets and grub screws for drive and steering system (see
• thread-locking compound
• suitable drive chain (see
• suitable cable and electrical connectors for the drive motor and clutch (see
Make sure you have obtained these additional parts before you start installation.
Note:
(applies to Types 1 and 2)
protected for use in engine compartments
CE approvals - conforms to:
89/336/EC (EMC), EN60945:1997
94/25/EC (RCD), EN28846:1993
page 12
)
page 12
)
page 12
)
page 16
)