Shimano E6000 Series User Manual page 53

Display
Code
preconditions
The speed sensor
may have been
E014
installed in the
wrong position.
A communication
error between the
E020
battery and drive
unit was detected.
Battery connected
to drive unit
conforms with
E021
system standards
but is not
supported.
Battery connected
to drive unit does
E022
not conform with
system standards.
A setting error was
E030
detected.
The chain tension
may not have been
adjusted or the
E031
crank may have
been installed in
the wrong position.
Part of the cycle
computer's
E043
firmware may be
damaged.
Operational restriction when
an error is being displayed
Power assistance is not
provided during riding.
Power assistance is not
provided during riding.
Power assistance is not
provided during riding.
Power assistance is not
provided during riding.
Power assistance is not
provided during riding.
The assist function is not
available. (However,
electronic gear shifting will
still function.)
Power assistance is not
provided during riding.
47
Remedy
Contact the place of purchase or bicycle dealer.
Check that the cable between the drive unit and
battery is properly connected.
If the situation does not improve, contact the place
of purchase.
Contact your place of purchase or a local bicycle
dealer for assistance.
Contact your place of purchase or a local bicycle
dealer for assistance.
If the situation does not improve even after
pressing the battery power button and turning on
the power again, contact the place of purchase.
Contact the place of purchase or bicycle dealer.
Contact the place of purchase or bicycle dealer.