Shimano E6000 Series User Manual page 52

Display
Code
preconditions
Two or more assist
switches are
W030
connected to the
system.
A communication
error between the
- drive unit and the
motor unit was
detected.
Error
If an error message is displayed on the
entire screen, follow one of the procedures
below to reset the display.
• Press the power button of the battery.
• Remove the battery from the holder.
If resetting the battery power does not solve the
problem or the same problem occurs frequently,
contact the place of purchase.
List of errors
Display
Code
preconditions
A system error was
E010
detected.
The initialization
E012 of the torque
sensor failed.
An anomaly was
E013 detected in the drive
unit's firmware.
Operational restrictions
while warning is
displayed
Gear shifting is not
available for electronic
derailleurs.
Gear shifting is not
available for electronic
derailleurs.
Operational restriction when
an error is being displayed
Power assistance is not
provided during riding.
Power assistance is not
provided during riding.
Power assistance is not
provided during riding.
46
Remedy
Change the assist switch to the gear shifting switch, or
connect only one assist switch and turn on the power
again.
If the situation does not improve, contact the place of
purchase.
Check that the cable is properly connected between the
drive unit and the motor unit.
If the situation does not improve, contact the place of
purchase.
<SC-E6000>
Press the power button of the battery to turn it on
again.
If the situation does not improve, contact the place
of purchase.
With your foot off the pedal, press the battery
power button and turn on the power again.
If the situation does not improve, contact the place
of purchase.
Contact the place of purchase or bicycle dealer.
<SC-E6010>
Remedy