Clearing Paper Jams; In The Paper Feed Area - Samsung CLP-650 Series User Manual

Clearing Paper Jams

N
: When removing paper that is jammed in the printer, if
OTE
possible always pull the paper in the direction that it normally
moves so as not to damage internal components. Always pull
firmly and evenly; do not jerk the paper. If the paper tears,
ensure that all fragments of paper are removed; otherwise a
jam will occur again.
When a paper jam occurs, a lamp turns on at the corresponding
location on the Status map of the control panel. The display on
the control panel also tells you where the paper jam has
occurred. Refer to the table below to locate the paper jam and
to clear it:
LED on
Message
Status Map
Jam0 In Tray1
Jam0 In MP Tray
Jam
Inside Printer
Jam
In Exit Area
Jam0 In Tray2
To resume printing after clearing paper jams, you must open
and close the access door.
Location of
GoTo
Jam
In the paper page 7.4
feed area
In the multi- page 7.5
purpose tray
Inside printer page 7.6
In the paper page 7.7
exit area
In the optional page 7.9
Tray2
7.4
Solving Problems

In the Paper Feed Area

If paper is jammed in the paper feed area, a lamp turns on at
the corresponding location on the Status map. Also, "Jam0 In
Tray1" appears on the display.
1
Using the handle, completely open the access door.
2
Carefully remove the paper by pulling in the direction as
shown below. Go to step 6.
If you cannot find the jammed paper, or if there is any
resistance removing the paper, stop pulling, and go to step
3.
C
:
AUTION
• Do not touch the green surface, the OPC drum, on the front
of each toner cartridge with your hands or any other
material. Use the handle on each cartridge in order to avoid
touching this area.
• Be careful not to scratch the surface of the paper transfer
belt.
• If you leave the access door open for more than a few
minutes, the OPC drum can be exposed to light. This will
cause damage to the OPC drum. Close the access door
should the installation need to be halted for any reason.