Installing Mono Printer Driver - Samsung CLP-610 Series User Manual

Installing mono printer driver

This printer features a monochrome-only printer. This mono
driver limits output to the black toner, so you can use your
printer as a monochrome printer. You must install the mono
driver on your computer. Following steps guide you through the
step by step installation process.
1
Make sure that the printer is connected to your computer
and powered on. Or your computer and printer are
connected to the network.
2
Insert the supplied CD-ROM into your CD-ROM drive. The
CD-ROM should automatically run, and an installation
window appears.
3
Click Cancel.
If the confirmation window appears, click Finish.
4
Click Start Printers and Faxes.
5
Select Add Printer.
6
When Add Printer Wizard appears, click Next.
7
Select Local printer attached to this computer, and
Automatically detect and install my Plug and Play
printer, then click Next. Go to step 13.
If your computer does not find the printer, then follow the
next step.
8
Select Next in the Select a Printer Port window.
9
In the Select a Printer Port window, select Have Disk....
10
Click Browse to find a mono driver for your printer.
ex) Windows XP 32 bit
Select CD-ROM drive Printer
WINXP_2000_VISTA-32
11
Select ***.inf file and click Open.
PC_MONO
12
Installing Printer Software in Windows
12
Click OK in the Install From Disk window.
13
Select a mono driver in the Printers field, and click Next.
N
: If you have installed a mono driver before, then the
OTE
Use Existing Driver window. Select as the window explains,
and click Next. Also, depending on your computer
configuration, the printer sharing window or the print the test
page window may appear; make the appropriate selection.
14
Enter your printer name, and click Next.
15
Click Finish to start installing a mono printer driver.
N
: If your printer is connected to a network, go to
OTE
printer's Properties and select the Ports tab, then click Add
Portand Standard TCP/IP Port, and create a new port to
connect to the printer. To create a new port, follow the
procedure laid out in the wizard window.