Understanding Display Messages - Samsung CLP-610 Series User Manual

5 Pull the jammed paper out in the direction shown. To avoid tearing
the paper, pull it out gently and slowly.
6 Close the front cover firmly. The machine will resume printing.
Caution
If the front cover is not completely closed, the machine will not
operate.

Understanding display messages

Messages appear on the Smart Panel program window or on the control
panel display to indicate machine status or errors. Refer to the tables
below to understand the messages meaning to correct the problem, if
necessary. Messages and their explanations are listed in alphabetical
order.
Note
• When you call for service, it is very convenient to provide the
service representative with the contents of the display message.
• If the message is not in the table, cycle the power and try the
printing job again. If the problem persists, call for service.
• Some messages may not appear in the display depending on
options or models. If so, it is not applicable to your machine.
* xxx indicates the media type.
* yyy indicates the tray.
Message
[yyy] The tray cassette is
not inserted, or not
Cassette Out
properly closed.
[yyy] There is no paper in
the tray.
Paper Empty
ADC Not There is a problem
Confirm Error in the ADC (Analog
to Digital Converter)
of your machine.
ADC Slope Error The temperature
Cycle Power slope for ADC
(Analog to Digital
Converter) detects
the value out of the
normal range.
Adjusting... The machine is
Registration adjusting the color
registration.
Deve Motor There is a problem
Locked with the
development motor
to machines which
moves the toner
supply device.
Door Open/Check The front cover or
Transfer Belt the top cover is not
securely latched.
7.7
<Troubleshooting>
Explanation Solution
To close the tray,
lower the rear edge,
align it with the slot,
and slide it into the
printer.
Load paper in the
tray. (Page 4.4)
Cycle power. If the
problem persists,
contact the service
representatives.
Cycle power. If the
problem persists,
contact the service
representatives.
Wait a few minutes.
Cycle power. If the
problem persists,
contact the service
representatives.
Close the cover until it
locks into place.