Samsung CLP-310W User Manual page 50

CONDITION SUGGESTED SOLUTIONS
• The paper may not meet specifications; for
Toner specks
example, the paper is too moist or too
AaBbCc
rough. See page 31.
• The paper path may need cleaning. See
AaBbCc
"Cleaning the inside" on page 38.
AaBbCc
AaBbCc
AaBbCc
If faded areas, generally rounded, occur
Dropouts
randomly on the page:
• A single sheet of paper may be defective.
AaBbCc
Try reprinting the job.
AaBbCc
• The moisture content of the paper is
uneven or the paper has moist spots on its
AaBbCc
surface. Try a different brand of paper. See
AaBbCc
page 31.
• The paper lot is bad. The manufacturing
AaBbCc
processes can cause some areas to reject
toner. Try a different kind or brand of
paper.
• Change the printer option and try again. Go
to printer properties, click Paper tab, and
set type to Thick Paper. Refer to the
Software section for details.
If these steps do not correct the problem,
contact a service representative.
White spots appear on the page:
White Spots
• The paper is too rough and a lot of dirt from
the paper falls to the inner devices within
the machine, which means the transfer belt
may be dirty. Clean the inside of your
machine. Contact a service representative.
• The paper path may need cleaning.
Contact a service representative.
If black vertical streaks appear on the page:
Vertical lines
• The imaging unit has probably been
scratched. Remove the imaging unit and
install a new one. See page 42.
If white vertical streaks appear on the page:
• The surface of the LSU part inside the
machine may be dirty. Clean the LSU by
opening and closing the front cover several
times and if the problem still occurs call the
contact a service representative.
50 _Troubleshooting
CONDITION SUGGESTED SOLUTIONS
If the amount of background shading becomes
Color or Black
unacceptable:
background
• Change to a lighter weight paper. See
page 31.
• Check the machine's environment: very dry
(low humidity) or high humidity (higher than
80% RH) conditions can increase the
amount of background shading.
• Remove the old toner cartridge and install
a new one. See page 41.
• Clean the inside of the machine. See page
Toner smear
38.
• Check the paper type and quality. See page
31.
• Remove the toner cartridge and install a
new one. See page 41.
If marks repeatedly appear on the printed side
Vertical repetitive
of the page at even intervals:
defects
• The toner cartridge may be damaged. If a
repetitive mark occurs on the page, print a
cleaning sheet several times to clean the
cartridge. After the printout, if you still have
the same problems, remove the toner
cartridge and install a new one. See page
41.
• Parts of the machine may have toner on
them. If the defects occur on the back of
the page, the problem will likely correct
itself after a few more pages.
• The fusing assembly may be damaged.
Contact a service representative.
Background scatter results from bits of toner
Background scatter
randomly distributed on the printed page.
• The paper may be too damp. Try printing
with a different batch of paper. Do not open
A
packages of paper until necessary so that
the paper does not absorb too much
moisture.
• If background scatter occurs on an
envelope, change the printing layout to
avoid printing over areas that have
overlapping seams on the reverse side.
Printing on seams can cause problems.
• If background scatter covers the entire
surface area of a printed page, adjust the
print resolution through your software
application or the printer properties.