Installing The Driver Software - Samsung CLP-310W User Manual

3. Click Wireless and Select Wizard. Then, click Next.
Wizard will help you setup the wireless network configuration.
However, if you want to set the wireless network directly, select
Custom.
4. Select the one Network Name(SSID) in the list.
• SSID: SSID(Service Set Identifier) is a name that identifies a wireless
network. Access points and wireless devices attempting to connect
to a specific wireless network must use the same SSID. The SSID is
case-sensitive.
• Operation Mode: Operation Mode refers to the type of wireless
connections.
- Ad-hoc: allows wireless devices to communicate directly with each
other in a peer-to-peer environment.
- Infrastructure: allows wireless devices to communicate with each
other through an access point.
If your network's operation mode is Infrastructure, select the SSID
of the access point. If the operation mode is Ad-hoc, select the
machine's SSID. Note that "airportthru" is the default SSID of your
machine.
5. Click Next.
If wireless security setting window appears, enter the registered
password (network key) and click Next.
6. Wizard Setup Confirmation window appears, please check your
wireless setup. If the setup is right, click Apply.
7. Click OK.
Disconnect the network cable (standard or crossover). Your
machine should then start communicating wirelessly with the
network. In case of Ad-hoc mode, you can use a wireless LAN
and wired LAN simultaneously.
If Operation Mode is Infrastructure, you must disconnect the
network cable to activate wireless network after completing the
network setting.
Now go to Installing the driver software.

Installing the driver software

You must install the printer driver software for printing. The software
includes drivers, applications, and other user friendly programs.
• The following procedure is based on Windows XP. The procedure
and popup window which appears during the installation may differ
depending on the operating system, machine features, or the
interface in use.
• Make sure that the network setup for your machine is completed.
(See "Setting up the network" on page 21.) All applications should
be closed on your computer before beginning installation.
If your IP assignment method is DHCP and IP address can be changed
whenever machine is turned on, we recommend you to use the Bonjour
program. Go to the http://developer.apple.com/networking/bonjour/
download/, select the program Bonjour for Windows according to your
computer operating system, and install the program. In case of Mac OS X,
this program might be already installed in your PC. This program will allow
you to fix the network parameter automatically. This Bonjour program does
not support Linux.
If your IP assignment method is static, follow the steps below.
1. Insert the Printer Software CD-ROM into your CD-ROM drive. The CD-
ROM should automatically run, and an installation window appears.
2. Click Next.
Getting started_ 29