Introduction; Receiving & Inspecting The Unit - N'Finity 3000 User Manual

Thank you for purchasing an N'FINITY cooling unit. We strive to provide the highest-quality products and the best possible
customer service. If you have any questions about your N'FINITY unit, please call us at 1-800-648-6058.
This owner's manual is intended to assist in the proper installation and maintenance of the N'FINITY cooling system. In order to
ensure the longevity of your cooling unit, the equipment should be installed correctly and have a proper care and maintenance
schedule. Please read and review this manual carefully and keep it for future reference.
What is the N'FINITY Cooling System?
The N'FINITY system is a specialized refrigeration unit designed for one purpose only: to maintain the optimal temperature and
humidity levels conducive to the proper storage and aging of fine wines. It is a self-contained cooling unit designed to be
used as a forced-air, through-the-wall unit. Standard through-the-wall N'FINITY units are temperature-controlled by an air
sensor. The N'FINITY unit can be set at any temperature within the acceptable wine-aging range of 50°F to 67°F. It is
designed to cool 30°F cooler than the ambient temperature of the space to which it is exhausting.
RECEIVING & INSPECTING THE UNIT
Upon receiving your N'FINITY unit:
• Lift only at the designated hand-hold locations on the shipping container, or fully support the unit from underneath.
A shipment may include one or more boxes containing accessories.
• Inspect the packaging for any obvious signs of damage or mishandling before opening the container.
• Note any discrepancies or visual damage on the bill of lading before signing.
• Place the box containing the N'FINITY unit on a tabletop to prepare it for testing prior to installation.
• Sit unit upright for 24 hours.
• Review the packing slip to verify the package's contents.
• Check the model number to ensure it is correct.
• Check that all factory options ordered are listed.
NOTE: N'FINITY units are manufactured in the USA and tested prior to shipment.
Check the box for the following contents:
Accessory kit #1:
•
•
Accessory kit #2:
•
•
•
•
•
•
Please leave the unit in its original box until you are ready for installation. This will allow you to move the product safely
without damaging it. When you are ready to remove the product from the box, refer to pages 7-11 for installation instructions.
TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
Page 2

INTRODUCTION

N'FINITY 3000 and 4200
(1) N'FINITY owner's manual
(1) Single-piece mounting bracket
(1) Piece of 1/2" ID clear plastic tubing (10 feet)
(2) 165/8" strips of insulation foam tape
(2) 173/8" strips of insulation foam tape
(10) 13/4" hex-head screws
(6) #8-18 x 3/8" Phillips pan AB T/S black oxide screws
(1) 1/2" NPT x 1/2" hose ID x 1/2" hose ID tee fitting
•
(18) Antimicrobial pan tabs
• (1) Drain line brush
WE 060517