Tait T02-00005-ACAA Installation Instructions

T02-00005-ACAA Desktop Microphone
Installation Instructions
Introduction
The T02-00005-ACAA desktop microphone
is an omnidirectional Electret microphone
which can be used in dispatch situations,
where the microphone is positioned on a flat
surface. The desktop microphone plugs into
the microphone socket on the radio control
head.
Operation
Press the key to transmit. Speak clearly
PTT
into the microphone and release the
when you have finished talking.
To use the Monitor function, press the
key and check whether the channel
MONITOR
is clear. When Monitor is active, the
to turn Monitor off. The LED goes out. If the channel is clear, press the
If the key is programmed, press it to activate the function.
FUNCTION
Installation
Notice
The desktop microphone grommet must be installed whenever the desktop
microphone is plugged into the microphone socket. When installed, the grommet has two
functions:
to prevent damage to the microphone socket when there is movement of the
■
microphone cord, and
to ensure that the control head is sealed against water, dust and other
■
environmental hazards.
1 Make sure that the radio is turned off.
2 Plug the microphone cord into the microphone socket on the radio control head.
3 Slide the grommet along the cord and push two adjacent corners of the grommet into
the microphone socket cavity.
4 Squeeze the grommet and push the remaining corners into position.
5 Check that the grommet is seated correctly in the cavity.
© Tait Limited May 2013
www.taitradio.com
402-00083-01
key
PTT
grommet
LED lights up. Press the
MONITOR
key
FUNCTION
LED
MONITOR
key
MONITOR
key
PTT
key again
MONITOR
key to transmit.
PTT