Tait TMAA10-08 Installation Instructions

TMAA10-08 Desktop Microphone
Installation Instructions
Introduction
The TMAA10-08 desktop microphone is an
omnidirectional Electret microphone which
can be used in dispatch situations, where the
microphone is positioned on a flat surface.
The desktop microphone plugs into the
microphone socket on the radio control head.
The desktop microphone has an internal pre-
amplifier and an adjustable output control on
the underside of the desktop microphone base.
Operation
Press the key to transmit. Speak clearly into
PTT
the microphone and release the
you have finished talking.
To use the Monitor function, press the
key and check whether the channel is clear. When Monitor is active, the
MONITOR
LED lights up. Press the
channel is clear, press the
If the key is programmed, press it to activate the function.
FUNCTION
Installation
Notice The desktop microphone grommet must be installed whenever the desktop
microphone is plugged into the microphone socket. When installed, the grommet has two
functions:
to prevent damage to the microphone socket when there is movement of the
■
microphone cord, and
to ensure that the control head is sealed against water, dust and other environmental
■
hazards.
1. Make sure that the radio is turned off.
2. Plug the microphone cord into the microphone socket on the radio control head.
3. Slide the grommet along the cord and push two adjacent corners of the grommet into
the microphone socket cavity.
4. Squeeze the grommet and push the remaining corners into position.
5. Check that the grommet is seated correctly in the cavity.
© Tait Limited November 2012
www.taitradio.com
402-00046-01
key when
PTT
key again to turn Monitor off. The LED goes out. If the
MONITOR
key to transmit.
PTT
grommet
FUNCTION
MONITOR
key
MONITOR
key
PTT
MONITOR