Installation Steps - Hayes ENERGIZE III Installation Manual

Installation Steps

1. Install the mounting bracket to a solid surface under the tow vehicle dash using the two machine
screws and fasteners provided. Tighten until snug. See Figure 3 – attachment of mounting
bracket.
2. Insert four of the self tapping screws provided through the mounting bracket holes and into the
desired controller anchor holes. Tighten until snug.
3. Mount in a location which allows the driver to easily apply the manual override and to see
the red indicator light.
WARNING:
!
• Use of longer screws than those provided can damage the unit and cause
!
WARNING:
CAUTION:
!
• Care must be taken to ensure that the mounting surface is rigid enough to
• Excessive vibration may result in poor performance.
loss of braking.
• All four controller wires must be connected properly for the controller to
operate correctly.
• Failure to properly connect all four wires can cause loss of trailer braking.
• Improper wiring will destroy the controller and void the manufacturer's
warranty.
prevent excessive vibration.