Advertisement
The vacuum cleaner is not suitable for use on con-
struction sites.
= Vacuuming up building rubble could damage the
>
appliance.
When not in use, switch off the appliance and pull out
the mains plug.
At the end of its life, the appliance should immediately
be rendered unusable, then disposed of in an approp-
riate manner.
!
Please note
The mains socket must be protected by at least a 16
amp circuit breaker.
If a circuit breaker is tripped when you switch on the
vacuum cleaner, this may be because other electrical
appliances which have a high current draw are con-
nected to the same power circuit.
To prevent the circuit breaker from tripping, select
the lowest power setting before switching the appli-
ance on, and increase the power only once it is run-
ning.
Disposal information
Packaging
The packaging is designed to protect the vacuum
cleaner from being damaged during transportation. It
is made of environmentally friendly materials and can
therefore be recycled. Dispose of packaging that is
no longer required at an appropriate recycling point.
Old appliance
Old appliances still contain many valuable materials.
Therefore, please take appliances that have reached
the end of their service life to your retailer or recyc-
ling centre so that they can be recycled. For current
disposal methods, please enquire at a retailer or your
local council.
Disposal of filters and dust bags
Filters and dust bags are manufactured from en-
vironmentally friendly materials. Provided they do
not contain substances that are not permitted in
household waste, you can dispose of them with your
normal household waste.
Notes on the energy label
This vacuum cleaner is a general purpose vacuum clea-
ner with a primary hose.
To achieve the energy efficiency rating and cleaning
effectiveness rating on carpets, please use the inter-
changeable universal nozzle.
To achieve the energy efficiency rating and cleaning ef-
fectiveness rating on hard floors with gaps and cracks,
please use the supplied hard-floor nozzle without the
clip-in edge cleaning bristles.
These calculations are based on the Commission Dele-
gated Regulation (EU) No. 665/2013 of 3rd May 2013
supplementing Directive 2010/30/EU. Unless other-
wise stated, all the procedures referred to in these
instructions were carried out in accordance with the
EN 60312-1:2017* standard.
*As the motor service test is carried out with the dust
collector empty, the stated motor service life must be
increased by 10% for tests with the dust collector half
filled.
3
Advertisement
