Advertisement
2.8w laser add on is identical for OX and R7.
If opted for during purchase a J-tech 2.8w complete laser system will be added to the order.
Safety:
Please open this package and carefully read and understand the safety warnings associated with this
product included in the package.
Lasers are dangerous, fire hazards and eye safety should always be the end user's top priority when
using the laser add on feature.
Never leave the laser unattended when in operation!
Always wear the safety glasses provided in the kit when using the laser diode add on. If more than
one party is in the local vicinity they should also have the required eye protection.
It is suggested to keep fire suppression equipment close at hand and prepared for an emergency.
SMW3D, Hobby-Fab, J-Tech and affiliated groups hold no liability to property, personal, or any other
damage created from the use of this product. The purchase and use of this laser add on system is
strictly the end user's liability and responsibility to ensure safe use.
Specifications:
Please see the J-tech instruction manual for full details.
https://jtechphotonics.com/wp-content/uploads/2013/05/Instruction-Manual-445nm-Laser-Diode-
Component-9mm-G2-Lens-J-Tech-Photonics-Inc.-v2.pdf
Bill of Materials:
•
2.8w J-tech laser system with extended wires
•
Modified spindle clamps
•
2 quantity M3 x 12mm bolts
Installation:
The spindle clamps in your kit will have 2 additional holes tapped into the side of one of the spindle
clamps. There will be two bolts pre-installed in the spindle clamp.
This clamp will be the lower clamp on the spindle closer to the collet side of the spindle.
Laser install instructions
Last updated: 08/13/20108
Rev. 9
36
Advertisement
